I would like to fit a different AGM battery

I would like to fit a different AGM battery

For systems using the PX300 charger (EC400/EC400+, EC500, EC600, EC700, EC800, & EC328):

Whilst we do not recommend any specific make or model of battery, the PX300 charger used in these systems is compatible with the majority of good quality AGM batteries available in the UK.

The charge profile of the PX300 is shown in the instruction manual attached below.  If you are in any doubt as to the fitment of a battery you should confirm with the battery distributer / manufacturer that the PX300 charge profile is suitable.

    • Related Articles

    • Leisure Battery Testing

      Introduction This guide has been put together to help test and diagnose cases where a caravan or motorhome user is experiencing leisure batteries discharging or not lasting as long as expected and refers to electrical systems supplied by Sargent ...

    • The battery current reading seems incorrect on my EC700 / EC800 control panel.

      If the battery current reading seems incorrect on any of the listed control panels, you may need to calibrate the current sensor in the PSU to the control panel in order to get a true reading. Ensure the mains charger is switched off at the ...

    • I would like to fit a second battery to my Auto-Trail motorhome

      Fitting a second leisure battery to an Auto-Trail vehicle is usually straight forward.  All current and most older models come equipped with a dedicated connector to allow an additional battery harness to be plugged in, making the whole process a ...

    • I would like to fit a Lithium battery

      NOTE: Most of the Sargent systems have a Battery Charger like a PX300 or PF200 connected to the system. If your vehicle has another charger fitted, please consult the manufacturers manual to check it's compatibility with Lithium batteries. The PX300 ...

    • The battery current reading seems incorrect on my EC620 control panel

      If the battery current reading seems incorrect on your EC620 control panel, you may need to calibrate the current sensor in the PSU to the control panel in order to get a true reading.​ Ensure the mains charger is switched off at the EC600 PSU.  If ...