Symbol | Function | Description |
12V Power Selection - Leisure Battery | This switch turns on (or off) the 12-volt power from the Leisure battery. Place the switch in the down position to draw power from the Leisure battery. Place the switch in the centre position to turn the power off. | |
12V Power Selection - Vehicle Battery | This switch turns on (or off) the 12-volt power from the Vehicle battery. Place the switch in the up position to draw power from the Vehicle battery. Place the switch in the centre position to turn the power off. NOTE: The vehicle battery should only be used for short periods of time / small loads otherwise the battery may become discharged and could prevent the vehicle from starting. | |
Awning Light | This switch operates the external awning light. | |
Water Pump | This switch turns on power to the internal water pump ready for use. It can be used to turn off the pump over night to avoid any noise from the pump. NOTE: A green indicator lamp will illuminate within the bottom left corner of the battery gauge when the pump motor is running. | |
Battery Level Test | This switch is used to display the
battery voltage level. Press and hold
the switch to display the battery level on the gauge. The green region indicates a battery with a good
charge, the yellow region indicates a battery with an adequate charge, and the
red region indicates a battery that requires charging. | |
Water Level Test | This switch is used to display the
fresh water level within the onboard water tank. Press and hold the switch to display the
water level on the gauge. The gauge indicates the water level on an ‘Empty - ¼ -
½ - ¾ - Full’ scale, with empty being on the left. | |
Waste Level Indicator 3/4 Full | This Red indicator illuminates when the water level in the waste water tank is greater than or equal to 75% full. | |
Waste Level Indicator 1/2 Full | This Amber indicator illuminates when the water level in the waste water tank is greater than or equal to 50% full. | |
Optional Remote Control Unit | When using the optional remote control unit, please ensure the control panel ‘12v Power’ switch is in either the Leisure or Vehicle battery (ON) position and the ‘Entry light’ switch is in the OFF position for correct operation of the remote control (as the remote control operates in parallel with the control panel switches). The remote control button [I] controls the Entry Light and button [II] controls the 12v Power. If you do not wish to use the remote control, or the remote battery is flat / remote has been lost, you can of course return to manual operation by using the switches on the control panel. If the power has been turned off using the remote control and then the remote has been lost / battery become flat you will need to carry out the following to reset the motorhome: Place the power selector switch in the centre (OFF) position and turn the charger switch to the OFF position, wait 5 seconds and then turn the charger & power selector switch back on. The UH**** number on the back of the remote control is the remote code number. Please keep a record of this number in case you need to order a replacement or additional remote control. |